Starter Strip Vinyl Siding Bottom

Required accessory for starting a vinyl siding job constructed of low maintenance durable vinyl backed by ply gem s limited lifetime warranty.

Starter strip vinyl siding bottom.

To use a starter strip you have to start with a whole piece. For the remaining vinyl siding panels to be installed correct and level beginning with the lowest row you must install the starter strip correctly. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in.

As its name implies a starter strip is one of the initial steps during the installation of vinyl siding. Find vinyl siding starter strips at lowe s today. In this way no j is used. In this case you ll need to maintain the starter strip height on both sides of the.

If your home has a deck it s likely to be suspended from a wall and covering the bottom of the existing siding. Vinyl siding starter strips snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. It is a small strip of vinyl siding that has a locking channel on it that the first full sized vinyl siding panel. This is where the new siding will begin.

Below the top of the foundation but the lower the vinyl siding is installed the better. Get started installing vinyl siding with this video that covers wall preparation fasteners fastening techniques tools chalk lines corner posts and start. It protects the sheathing from rain snow and pests. You attach the bottom of the first row of siding to the top of this starter strip.

Starter strip is used at the bottom of each side of the home to lock the first course of siding in place. The starter strip is the first strip of vinyl siding that is nailed to the wall.